Never lose a body clip again. These handy retainers secure to the hull to keep your body clips close at hand. Set of four.Replacement part for these models:DCB M41 WidebodySpartan®..
This is 5460-series GTR shock hardware includes upper caps with hollow balls (2), bottom caps (2), and upper and lower spring retainers (2).Replacement part for these models:E-Revo® VXL BrushlessJato®Revo®Slayer® Pro 4X4SummitXO-1®..
The center half-shaft set includes front internal-spline halves (2), rear internal-spline halves (2), two external-spline halves, and pin retainers (4).Replacement part for these models:TRX-4® 1972 Chevrolet® Blazer® High Trail Edition™TRX-4® 1979 Chevrolet® Blazer®TRX-4® 1979 Ford® Bronco®TRX-4® Ch..
This is a eplacement steering arm mount with standard and maximum-throw steering stops.Replacement part for these models:E-Revo® VXL BrushlessRevo®Slayer® Pro 4X4Summit..
The extended battery hold down for the Stampede 4X4 allows for LiPo packs of up to 42 mm tall to fit in the stock battery tray. Includes extended hold down, post, and body clip.Accessory part for these models:Stampede® 4X4 VXL..
Customize your Drag Slash® Chevrolet® C10 body with these molded body accessories. The gloss black finish gives your truck an extra dose of style. Includes upper and lower grilles, headlight housings, front and rear bumpers, retainers, and hardware.Replacement part for these models:Drag Sl..
These left & right axle carriers require larger 6x13 mm ball bearings (sold separately. Includes bearing adapters for 6x12 mm ball bearings (2) and dust boot retainers (4).Replacement part for these models:Revo®Slayer® Pro 4X4SummitAccessory part for these models:T-Maxx®..
This is a Battery hold-down with front and rear retainers for vehicles equipped with the low-CG 4X4 chassis. Does not fit standard chassis.Replacement part for these models:Ford® Fiesta® ST RallySlash 4X4 Ultimate..
Extended battery hold-down with front and rear retainers accommodates taller batteries on vehicles equipped with the low-CG 4X4 chassis. Does not fit standard chassis. For a complete chassis conversion, use kit 7421.Accessory part for these models:Ford® Fiesta® ST RallySlash 4X4 Ultim..
This is a Set of four replacement suspension pin retainers for hardened steel suspension pins.Replacement part for these models:X-Maxx®XRT®Accessory part for these models:Maxx®..