Radiolink R7FG 7 CH Channel RC Receiver with Gyro 2.4G HV Servo Drifting Crawler for Transmitter RC4GS/RC6GS/RC4G/T8FB

Properties: 【7 channels】: 7ch receiver suitable for Radiolink the transmitter RC4GS / RC6GS / T8FB Please note: we are not authorized vvbuy invite to sell it. 【Two-way back】: Real-time signal strength, battery voltage and other information can be returned. 【Sub ID gives remote control】: Can be specified in multiple coded receiver. 【Anti-reverse plug-in design】: Even if the power cable is plugged in, the receiver will not be damaged. 【FHSS Signal Spread Spectrum】: Take FHSS spectrum anti-interference technology, keeping the signal stable. 【Two Working Modes】: Support normal working mode and gyro function working mode, gyro integrated to keep the uni-direction and anti-slip. 【Built in Gyro】: come with the R7FG gyro integrated receiver is can keep the vehicle in a straight line during aggressive acceleration and braking, the receiver support up to 10v of servo. 【10 models memory】: Big storage of mode memory, it compatible all RC cars and boats.  Please note: 1. R7FG rc receiver suitable for Radiolink the transmitter RC4GS / RC6GS / RC4G / T8FB / RC3S. 2. TEr receiver gyroscope settings 1. Gyro Allow short press the code key three times (two times less than 1 second), the red light flashes three times, and the red light changes on and off to indicate if the gyroscope is activated. 2. Gyrophase, When the gyroscope is activated to move forward, the car body will rotate to see if the gyroscope is correcting the wheel. When turning the car body to the left, the wheel is corrected to the right, and when the car body is right, the wheel is corrected to the left. When the wheel is reversed, press the code button twice (two times less than 1 second), the red light flashes twice, and the gyroscope phase correction is complete. R7FG Receiver Specifications: Channel: 7 Model: Cars / boats Control distance: more than 600 m Spread Spectrum: FHSS Antenna length: 200mm Working current: 30mA Power supply: 4 ~ 10.0 V DC RF Power: <10dbm Channel resolution: 4096 Size: 30 * 18.5 * 11.5mm Weight: 6   How to play Code With Sender: 1. Place the transmitter and receiver close to each other within 50 cm. 2. Turn on the transmitter, then power on the R6FG. 3. there is a black button on the R7FG, press the binding button 2 seconds and release, receiver light will flash, after about flashing 8 times, match code success then receiver signal LED always on. 4. The antenna must be kept as straight as possible. Otherwise it will reduce the effective range. Working mode: R7FG PPM & SBUS cutover: Supports 1 ~ 6 channel PWM output and can output PPM or SBUS in the 7th channel. The user selects the PWM + PPM or PWM + SBUS output as needed. The factory standard 7th channel is the PPM output. By pressing the code button once in a short press (within a second), the 7th channel output switch between PPM and SBUS, and the green light will flash once to indicate that the button is valid. When the blue light goes on in the SBUS output mode,  Package Included: R7FG Receiver x 1