SkyRC "PROGBOX" 6-in-1 LCD ESC Smart Programmer Box w/PC Link

The SkyRC "PROGBOX" 6-in-1 ESC Smart Programmer Box is a sophisticated electronic device controlled by high-performance microprocessors designed for easy operation and multi-function use, all in a compact form factor.

The LCD screen displays two lines of data, with up to 16 characters per line. The user interface is intuitive and easy to read. The front panel includes four buttons which are used to operate the box for all functions. The side ports include motor sensor, USB, I/O connector and battery balance connector.

6-in-1 PROGBOX Functions:

1. ESC Programming: Use the Program Box to set program your ESC or make any changes track-side.       
   
2. PC Interface Link: The PROGBOX doubles as the SkyLINK using an USB adaptor which can be used to link the ESC with a PC. With this, you can update the firmware of the ESC or program the ESC by SkyLINK software on the PC.
3. PPM Signal Monitor: The PPM Signal Monitor function enables you to check the output voltage of the receiver and the radio's PPM signal width and frequency.    
   
4. Servo Tester: No need to power on your transmitter, you can check the servo function with the PROGBOX. Connect the servo to the Program Box, get the information of input voltage, servo travel position and peak current. There are two modes: one is Swing Mode and the other is Manual Mode.
   
5. Motor kV/RPM Tester: Connect your motor to the Program Box, input initial settings, move the throttle of the transmitter, and read the value of your motor kV, RPM and input voltage on the LCD screen.
6. LiPo Battery Monitor: Check the total cell number, total voltage, individual cell voltage, highest voltage and lowest voltage, and the voltage difference between the highest voltage and lowest voltage.
   

Specifications:
Dimension (LxWxH): 85x48.5x11.8mm         
Input Voltage (ESC Setting): 6-10VDC
Input Current (ESC Setting): 500mA
Idle Current (ESC Setting): <20mA
Operating Temperature: 0-40ºC
Storage Temperature: -10 — 60 ºC
Operating Humidity: 10 - 90%RH
Storage Humidity: 20 - 75%RH
Protection Class: IP20
Weight: 40g

Needed To Complete:

• For ESC programming directly from the PROGBOX, you will need a standard 3-wire receiver wire extension with two male ends, as it is not included with the PROGBOX; most SkyRC ESC's include this wire.
• For PC programming you will need a Micro USB to USB adapter.